0.00INR | 0 Item
View Cart | Checkout
 
 
Our Products
 
Trouble Shooting
If your Servo Voltage Stabilizer does not operate properly, please check the following points before calling for service.

SYMPTOM CAUSE REMEDY
No output No input supply call your Electrician
  Incoming voltage is out of range. Servo may be in cut-off mode. Use By-Pass mode
  MCB / Fuse may be shut off / blown Due to Over Loading Check your load
High / Low Output Contact our Service Voltages Input Voltage out of range Contact our Service Engineer
  Problem in Control Circuit Contact our Service Engineer

 
{short description of image}.
 

SAFETY INSTRUCTIONS

  1. The stabilizer should be installed in a fairy cool and well ventilated place.
  2. It should be kept above the floor level as far as possible.
  3. The chassis of the stabilizer must be connected to the earthing of the supply.
  4. The unit should be installed at the place protected from rain and water
     
 
Home  |  Profile  |  Our Product  |  Our Client  |  Trouble Shooting  |  Contact Us  |  Enquiry
Copyright 2008, All Rights Reserved, Site Developed by Linxsmart Technologies
Powered by Trademart.in and Retailmart.com